Stihl MS 500i

MS 500i64
29.1 Tools, aids
29 Tools, Servicing Aids
Part number Designation Use
0000 890 2201 Assembly tool Installing rope guide bushing
0000 890 2300 Screwdriver
0000 890 2800 Assembly hook Disassembling, assembling clutch
0000 893 3706 Jaws (with profile 3.1 + 4) Removing oil seals
0000 893 3711 Jaws (with profile 6) Removing oil seals
0000 893 5904 Locking strip Blocking the piston
0811 611 8200 Circlip pliers DIN5254-A10 or equivalent tool Removing, installing circlip
0812 542 2041 Insert T20x125 or similar tool Removing and installing hexagon socket head
screws with electric or pneumatic screwdrivers,
tightening with torque wrench
0812 542 2104 Insert T27x125 or similar tool Removing and installing hexagon socket head
screws with electric or pneumatic screwdrivers,
tightening with torque wrench
1108 893 4700 Assembly drift Removing, installing piston pins
1113 893 4600 Press sleeve Pressing out ball bearing
1117 890 0900 Assembly tube Installing chain brake spring
1141 893 4600 Assembly sleeve Installing the oil seal
1142 890 3400 Combination wrench
1142 893 2600 Clamping strap Installing the cylinder
1143 893 2400 Press sleeve Installing the oil seal
4119 893 2400 Press sleeve Removing, installing ball bearing
4180 893 4400 Extension piece Removing, installing crankcase half grommets
5910 840 0210 Analyzer MDG 1 Calibrating the chain saw; testing the chain saw,
replacing control unit
5910 840 0405 Diagnosis cable, fuel injection Calibrating the chain saw; testing the chain saw,
replacing control unit
5910 890 0302 Torque wrench with optical/acoustic signal or
equivalent tool
Screw connections (1 to 18 Nm / 9 to 159 lbf. in.)
5910 890 0312 Torque wrench with optical/acoustic signal or
equivalent tool
Screw connections (6 to 80 Nm / 5 to 59 lbf. in.)
5910 890 2212 Assembly tool Fitting snap ring on piston
5910 890 2222 Service tool AS Disassembling crankcase
5910 890 2301 Screwdriver T20 or equivalent tool Removing, installing hexagon head socket screws
5910 890 2308 Screwdriver T10 or equivalent tool Removing, installing hexagon head socket screws
5910 890 2405 Screwdriver Q-4x150
5910 890 2415 Screwdriver T27x200 or equivalent tool Removing, installing hexagon head socket screws
5910 890 2420 Screwdriver Q-SW 8x200 or equivalent tool Removing, installing hexagon head socket screws
5910 890 2800 Assembly hook
5910 890 3000 Stud puller, M8-7.5 Screwing in collar screws
5910 890 3101 Assembly stand
5910 890 3200 Cover Covering chain saw
5910 890 4000 Wiring tool Pressing wires into the guides
5910 890 4400 Puller Removing oil seals
5910 890 4504 Puller Removing the flywheel
5910 890 4505 Puller Remove crankshaft
5910 893 0501 Stud driver M8 Unscrewing collar screws
5910 893 2804 Insert 13 mm long or equivalent tool Removing, installing decompression valve