Stihl MS 500i - Page 67

MS 500i 65
5910 893 5301 Piston support Installing the cylinder
5910 893 5608 Insert DIN3124 SW 13 or equivalent tool Removing, installing the flywheel; removing,
installing hexagon bolts and nuts
5910 893 5610 Insert SW 17 or equivalent tool Removing, installing hexagon bolts and nuts
5910 893 5613 Insert DIN3124-S19x12.5L or equivalent tool Removing, installing clutch
5910 893 8800 Assembly hook Removing pickup body
5910 895 0901 Guide piece Remove crankshaft
Snipe nose pliers Pulling off blade receptacles, pulling out hoses
Hot-air blower Removing, installing ball bearing; removing,
installing crankshaft
Open end wrench 8 mm Holding nut steady on bumper spike
Open end wrench 14 mm Removing, installing handle heater switch
Nut M8 Disassembling crankcase
Needle Assembling ignition lead
Flat screwdriver 1.0x5.5x125 Fitting, removing shroud
Screwdriver PH1x80 mm Disassembling, assembling injection pump
Protective gloves
Drift 2 mm Knocking out segment of the starter; installing
rewind spring
Drift 3 mm Removing the oil seal
Drift 5 mm Removing, installing throttle trigger; removing
control unit; removing injection valve
Drift 6 mm Removing, installing tank vent valve
Flex ratchet wrench Removing clutch
0781 120 1110 STIHL multi-purpose grease Greasing pivot pin and brake lever; greasing seal-
ing lips of the oil seal; greasing starter stub;
greasing chain tensioner
0781 417 1315 STIHL special lubricant Installing rewind spring
0781 957 9000 STIHL press fluid OH 723 Installing rubber elements
0786 111 2101 Loctite 242 (thread-locking adhesive, medium
strength)
Securing screw on chain catcher; pivot pin in
gearbox
0786 111 2109 Loctite 270 (thread-locking adhesive, high
strength)
Securing collar screws on crankcase
CFC and HFC-free solvent-based degreasing
agent
Saw chain lubricant
* complete part number depending on the country
Part number Designation Use