MS 500i 31
The bore in the flywheel (3) and the crankshaft taper must
be degreased and free from oil.
N Fit the flywheel (3) on the crankshaft as far as stop so
that its spline (arrow) engages the slot (arrow) in the
crankshaft.
N Rotate the flywheel (3) clockwise by hand as far as
stop.
The piston is now blocked.
N Fit and tighten down the nut (4).
If the locking strip 0000 893 5904 slips out during
tightening:
N Push the locking strip 0000 893 5904 into the spark
plug hole and hold it there.
N Fit and tighten down the nut (4).
N Pull the locking strip 0000 893 5904 out of the spark
plug hole.
N Install the spark plug (1).
N Fit the spark plug boot (2) so that its tab (arrow) is
seated in the recess in the airflow shroud.
N Install the fan housing with rewind starter, @ 10.11.
N Mount the shroud.
N Remove the filter cover
N Calibrate the saw, @ 4.
The controller is optimally adjusted to suit the mechanical
and mechatronic components.
0000-GXX-5609-A00000-GXX-5610-A0
To Next Page
Loading...
