– Slowly insert the forks at the centre of the
load to be lifted.
CAUTION
Insert the fork without bumping into either the shelv-
ing or the load.
– Insert the forks as far as possible below the
load. If possible, the forks should be inser-
ted far enough in that the load is resting
against the fork carriage. The load centre of
gravity must be centred between the forks.
DANGER
Pay attention to the part of the forks protruding
from the load to be lifted.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
– Lift the load a few centimetres from the
ground and read the "Transporting loads"
section.
Load pick up from shelving.
– Approach the shelving at moderate speed.
Use the drive control throttles to gradually
slow down and stop the truck perpendicular
to the shelving with the tiller in the braking
position.
– Check that there is sufficient space be-
tween the forks and the shelving.
Use
4
Moving the load
86 45728043478 EN - 11/2021 - 09
To Next Page
Loading...
Need help?
General
