– Raise the forks until you reach the correct
fork insertion height.
– Move the truck slowly forwards to insert the
forks into the load.
CAUTION
Insert the fork without bumping into either the shelv-
ing or the load.
– Insert the forks as far as possible below the
load. If possible, the forks should be inser-
ted far enough in that the load is resting
against the fork carriage. The load centre of
gravity must be centred between the forks.
DANGER
Pay attention to the part of the forks protruding
from the load to be lifted.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
– Raise the load a few centimetres until it is
resting fully on the forks. If the load is stable
and secure on the forks, proceed with the
following steps. In the event of uncertainty
and/or a load that is not properly secure or
stable, lower the forks and place the load
back on the shelving.
Use
4
Moving the load
8745728043478 EN - 11/2021 - 09
To Next Page
Loading...
Need help?
General
