STONEX R2W PLUS 500 - Measurement and Unit Configuration

R2W PLUS
18
3.1.1 Setting the measure condition
Operation:
1. The distance measurement mode will be: Fine, Coarse, Repeat Fine, Average Fine,
Tracking.
2. Tilt correction mode will be: HV, V, NO, Always off.
3. Collimator correction mode will be: Yes or
No.
4. CR correction mode will be: K=0.142,
K=0.2, No.
5. Sea Level correction mode will be: Yes or
No.
6. Target Type mode will be: Prism, No Prism,
Reflector.You could press “Enter” to keep the
setting or press canceled.
3.1.2 Setting the units
Operation:
1. Angle unit mode will be: DMS, GON,
MIL.
2. Angle Precision mode will be: 1 second,
0.1 second or 0.5 second.
3. Distance Unit mode will be: Meter, US
Feet, Feet.
4. Distance precision mode will be: 1mm or
0.1mm.
You could press “Enter” to keep the setting
or press canceled.