Stryker 1079 - Adjusting Trendelenburg;Reverse Trendelenburg Positions - Side Control; Adjusting Trendelenburg;Reverse Trendelenburg Positions - 3-Sided Controls

1-12 1079-009-005 REV E www.stryker.com
Return To Table of Contents
English
Operation Guide
ADJUSTING TRENDELENBURG/REVERSE TRENDELENBURG POSITIONS - SIDE CONTROL
Note: Litter height must be raised first in order to achieve a Trendelenburg or reverse Trendelenburg position.
CAUTION
To avoid damage, remove any equipment that may be in the way before raising or lowering the litter height.
For Trendelenburg positioning (head down), depress the side of pedal (B) closest to the head end (see Figure 1 on
page 1-9).
For Reverse Trendelenburg positioning (foot down), depress the side of pedal (B) closest to the foot end (see Figure
1 on page 1-9.
Note: The higher the litter is before pedal (B) is activated, the greater the Trendelenburg or reverse Trendelenburg
angle will be. (Maximum Trendelenburg angle is +18°. Maximum reverse Trendelenburg angle is -18°.)
ADJUSTING TRENDELENBURG/REVERSE TRENDELENBURG POSITIONS - 3-SIDED CONTROLS
CAUTION
To avoid damage, remove any equipment that may be in the way before raising or lowering the litter height.
For Trendelenburg positioning (head down), depress pedal (B) or the side of pedal (C) closest to the head end (see
Figure 2 on page 1-10).
For Reverse Trendelenburg positioning (foot down), depress the side of pedal (B) depress pedal (D) or the side of
pedal (C) closest to the foot end (see Figure 2 on page 1-10).
Note: The higher the litter is before pedal (B) is activated, the greater the Trendelenburg or reverse Trendelenburg
angle will be. (Maximum Trendelenburg angle is +18°. Maximum reverse Trendelenburg angle is -18°.)