EN-55
DRAFT
Electromagnetic Compatibility
Like other electrical medical equipment, the Crossre2 System requires
special precautions to ensure electromagnetic compatibility with other
electrical medical devices. To ensure electromagnetic compatibility (EMC),
the Crossre2 System must be installed and operated according to the EMC
information provided in this manual.
The Crossre2 System has been designed and tested to comply with IEC
60601-1-2:2001 requirements for EMC with other devices.
Warning This equipment is intended for use by health care
professionals only. This equipment may cause radio
interference or may disrupt the operation of nearby
equipment. It may be necessary to take mitigation
measures, such as reorienting or relocating the equipment
or shielding the location.
Portable and mobile RF communications equipment can aect the normal
function of the Crossre2 System even if such equipment meets the
applicable emissions requirements.
Do not use cables or accessories other than those provided with the
Crossre2 System, as this may result in increased electromagnetic emissions
or decreased immunity to such emissions.
If the Crossre2 System is used adjacent to or stacked with other
equipment, observe and verify normal operation of the Crossre2 System
in the conguration in which it will be used prior to using it in a surgical
procedure as interference may occur. Consult the tables below for guidance
in placing the Crossre2 System.
To Next Page
Loading...
Need help?
General
