Stryker Crossfire 2 User Manual

EN-4
DRAFT
3. Electrosurgical components, such as the probe, may remain hot following
activation. Keep all electrosurgical equipment away from ammable
materials to avoid combustion.
4. To prevent the risk of re, DO NOT replace console fuses. If it is
suspected that fuses are damaged, return console to Stryker for repair.
Prior to Surgery
1. The operator of the Crossre2 system should be a qualied physician,
having complete knowledge of the use of this equipment and awareness
of the risks associated with arthroscopic and laparoscopic electrosurgical
procedures.
2. The operator of the Crossre2 system should be experienced in
arthroscopic and electrosurgical practices and techniques.
3. The operator of the Crossre2 system should read this manual
thoroughly and be familiar with its contents prior to operating the
equipment.
4. The operator of the Crossre2 system should be sure that the system
functions as outlined in this manual prior to a surgical procedure. The
Crossre2 system was fully tested at the factory before shipment.
5. Crossre2 system components are designed to be used together as a
system. Use only the appropriate footswitch, handpiece, and disposable
attachments described in this manual.
6. Carefully unpack the unit and ensure that all components are accounted
for and remain undamaged from shipment. Inspect the handpiece cable
for any damage to insulation. If damage to any component is detected,
refer to the “Service and Claims” section of this manual.
7. Ensure the proper connection of the primary power cord of the
Crossre2 System to a grounded receptacle. To prevent risk of electric
shock DO NOT use extension cords or adapter plugs.
8. DO NOT wrap the handpiece cable around metal objects, or the induction
of hazardous currents may result.
9. Position the cables to avoid contact with the patient, electrodes, cables,
and any other electrical leads which provide paths for high frequency
current.
10. Position the console so the fan directs the ow of air away from the
patient.
11. When the Crossre2 system and physiological monitoring equipment
are used simultaneously on a patient, position any monitoring electrodes
as far as possible from the surgical electrodes. Monitoring equipment
using high frequency, current-limiting devices is recommended. Needle

Stryker Crossfire 2 Specifications

General

Brand	Stryker
Model	Crossfire 2
Category	Medical Equipment
Language	English