SSeerrvviiccee
PPrrootteeccttiinngg aaggaaiinnsstt eelleeccttrroossttaattiicc ddiisscchhaarrggee ((EESSDD))
CCAAUUTTIIOONN
• Always use ESD protective equipment before opening antistatic bags and servicing electronic parts.
• Do not place unprotected circuit boards on the floor.
NNoottee -- Always ship back circuit boards to Stryker in the same antistatic bags that the new boards were originally shipped in.
The electronic circuits in the product are completely protected from static electricity damage when factory assembled.
Always use adequate static protection when servicing the electronic systems of the product. All service personnel must use
static protection whenever they are touching wires.
Sample antistatic protection equipment includes:
• 1 antistatic wrist strap
• 1 grounding plug
• 1 test lead with a banana plug on one end and an alligator clip on the other end
Make sure that you follow the ESD manufacturer’s instructions for appropriate protection against static discharge.
CCoovveerr rreeppllaacceemmeenntt,, ttoopp
TToooollss rreeqquuiirreedd::
• Zipper pull tool or equivalent
PPrroocceedduurree::
1. Apply the IInnTToouucchh brakes.
2. Unplug the support surface power cord.
3. Remove the headboard and footboards.
4. Lower all the siderails.
5. Unsnap the two secure snaps (C) at the foot end corners (Figure 2).
6. Unsnap the four corner retainers (B) (Figure 2).
7. Insert a zipper pull tool or equivalent through the hole in the zipper slider to unlock.
8. Unzip the support surface top cover from the bottom using the zipper pull tool or equivalent (A) (Figure 2).
NNoottee -- The zipper starts on the patient right side near the foot end.
2971-009-002 Rev D.0 25 EN
To Next Page
Loading...
Need help?
General
