EasyManua.ls Logo

Stulz BNB Series - Master;Slave Control Cabinet for Ultrasonic Humidifier (USM;USS Controller)

Stulz BNB Series
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© STULZ GmbH, Hamburg EN / 10-2015 / 1000683
-
31
-
STULZUltraSonic-SystemforDirectRoomHumidicationBNB- Open-loopandclosedloopcontrol
6.1. Master/slave control cabinet for ultrasonic humidier (USM/USS controller)
The USM controller is an open-loop and closed-loop control unit with inbuilt microprocessor for monitor-
ing,operatingandcontrollinganultrasonichumidier,andforactuatingadditionalcontrolunits(USS)in
the same humidity control circuit.
Thecontrolpanelincludesamasterswitchforthepowersupplytotheultrasonichumidier,fuses,anda
Siemens LOGO controller with display for setting and viewing current system values.
The display presents all the relevant data and factors as plain text and/or values. Alongside current hu-
midity,hereyoucanviewthecurrenthumidiercapacity,operatingstateandspeciedalarmmessages.
Thereasonforthealarmisdisplayed,whichsimpliestroubleshooting.Inaddition,themainalarmsacti-
vateaoatingcontact,whichcanbeusedforforwardingalarmstoacentralcontrolcenter.
Types of control
The varied capability of the microprocessor allows different types of control to be used, which means that
controlconceptscansubsequentlybemodiedwithoutanymajorsoftwareorhardwarechanges.
● Control via sensors:Themicroprocessorrecordshumidityandadjuststheultrasonichumidiers
proportionally. By modifying the parameter range, the humidifying system can be adapted to perfectly
suit requirements and ambient conditions.
Control via external control signal: The microprocessor processes a signal from an external con-
trollerandusesittoadjusttheultrasonichumidierproportionally.
Combination of humidity control and external control signal: The microprocessor can process the
followingsignalsfortheinputoftheroomairsensororreturnairsensor,oranexternalcontrolsignal:
- 0-10 V DC, - 0-1 V DC, - 0.2 - 1 V DC, - 2 - 10 V DC, - optionally 4-20 mA with additional converter
(optionalcontrolcabinetaccessory).
In addition to the control inputs, the microprocessor features two inputs for remote ON/OFF actuation.
What's more, the microprocessor offers the option of actuating a solenoid valve with a supply voltage of
48 V AC. Flushing cycles can be set, so that not only is the water tank drained in the summer months,
butthepipesareushedaswell.Thisensuresmaximumhygiene.
TVS(transientvoltagesuppression)diodesareswitchedparalleltothenebulizerprintplatesasprotec-
tion against overvoltage peaks.
The control units are fully wired and function tested at the factory.

Table of Contents

Related product manuals