Stulz BNB Series - 9 Operation

© STULZ GmbH, Hamburg EN / 10-2015 / 1000683
-
61
-
STULZUltraSonic-SystemforDirectRoomHumidicationBNB-  Operation
9. Operation
Whenhumidicationisrequired,theunitisautomaticallylledwithwateruptothenecessarylevel,and
atomization commences.
Themistproducedinthiswayisblownintotheroomairfromtheunit'sairow,humidifyingtheroom.
During this process, the water in the tank is kept at a constant level and the air humidity is maintained at
the set value.
Ifthewaterlevelinthetankfallsbelowasafetylevelduringoperation,aoatswitchshutsdownthe
ultrasonichumidier.
Ifthewatertemperatureisexceeded,theinternaltemperaturemonitoristriggered(40°C)andswitches
off the unit.
CAUTION
Automated ushing routines.
We recommend the use of STULZ UltraSonic master/slave control units USM/USS. These perform all
ushingroutinesautomatically.
Note
CAUTION
Do not remove mist outlets.
Mist outlets must not be removed during operation!
NOTICE
CAUTION
Do not operate without air lters.
Thehumidiermustnotbeoperatedwithoutairlters!
NOTICE
CAUTION
Never seal off mist outlets.
Never seal off the mist outlets!
NOTICE
CAUTION
For longer downtimes.
If the unit is not going to be used for longer periods, it must be drained!
NOTICE