Stulz ENS 18 A - Operation

© STULZ GmbH, Hamburg DE / 06-2016 / 1000687
-
57
-
STULZ UltraSonic -System for duct humidication ENS 14 A - 18 A- Operation
9. Operation
When humidication is required, the unit is automatically lled with water up to the necessary level, and
atomization commences.
The mist produced in this way is blown into the room air from the duct's airow, humidifying the room.
During this process, the water in the tank is kept at a constant level and the air humidity is maintained at
the set value.
If the water level in the tank falls below a safety level during operation, a oat switch shuts down the
ultrasonic humidier.
If the water temperature is exceeded, the internal temperature monitor is triggered (40°C) and switches
off the unit.
CAUTION
Automated ushing routines.
We recommend the use of STULZ UltraSonic master/slave control units USM/USS. These perform all
ushing routines automatically.
Note
CAUTION
Do not remove mist outlets.
Mist outlets must not be removed during operation!
IMPORTANT
CAUTION
Never seal off mist outlets.
Never seal off the mist outlets!
IMPORTANT
CAUTION
For longer downtimes.
If the unit is not going to be used for longer periods, it must be drained!
IMPORTANT