Stulz ENS 18 A - Start-UP

DE / 06-2016 / 1000687 © STULZ GmbH, Hamburg
-
54
-
Start-up STULZ UltraSonic -System for duct humidication ENS 14 A - 18 A-
8. Start-up
All steps from section "7. Installation" on page 31 must have been completed prior to start-up.
CAUTION
Electrical connections are secure.
After transport/delivery, check that electrical connections are secure and re-tighten if necessary.
WARNING
CAUTION
No obstacles in the blow-out area.
There must not be any obstacles in the blow-out area of the unit. Risk of condensation!
IMPORTANT
CAUTION
Stationary water in pipes.
Do not operate the humidier with stationary water in the pipes.
IMPORTANT
CAUTION
Alignment with airow.
Align the humidier in the direction of the airow.
IMPORTANT
CAUTION
Water and power supply.
Make sure the ultrasonic humidier is supplied with electrical power and demineralized water.
IMPORTANT
CAUTION
Space for maintenance and repair work.
The installation clearances from section "7.2. Installation clearances" on page 36 must be adhered to.
CAUTION
Check all connections.
Route and connect all power cables and water supply pipes correctly, securely and safely.
IMPORTANT
CAUTION
Operation < 0°C.
Do not operate the humidier if the room temperature drops below 0°C!
●
Drain the water tank of the unit.
IMPORTANT