Subaru 2012 Forester - Windshield Wipers; Daytime Running Lights

13
Getting
Started
Instrument
Panel
Gauges
Personalize Controls While
Operating
Safety / In Case
of Emergency
Additional
Information
13
Get
Gt
tin
ti
g
S
tarte
d
Ins
I
tru
m
e
n
t
Panel
Gau
G
ges
Per
P
son
ali
li
z
e
Con
trols
Whi
Whi
le
l
Operating
Saf
Sf
ety
t
/
/
In
I
Cas
C
e
of Emergency
Add
Add
iti
ii
o
n
a
l
l
Information
Controls
Windshield Wipers
To turn on the wipers, press the wiper control lever down
one level for intermittent, two levels for low, or three levels for
IJHITQFFE3FUVSOUIFMFWFSUPUIFi0''wQPTJUJPOUPTUPQ
the wipers. For a single wipe move the lever up. To spray
washer uid, pull and hold the lever toward you.
To operate the rear wiper, rotate the end of the knob upward
to the intermittent, continuous, or wash position. When the
rear wiper is off, rotate the knob downward to wash and
wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a
reduced brightness high beam will be automatically turned
on when the engine has started and the parking brake is
GVMMZSFMFBTFEBOEUIFMJHIUTXJUDIJTJOUIFi0''wPSi w
position. The brightness of the illumination of the high beam
headlights is reduced by the daytime running light system.
You must always switch on your headlights when it’s dark
outside by turning the light switch to the
position.
1
2
3
INT.
LOW
HIGH
OFF