Subaru 2012 Forester - Current Fuel Consumption (if Equipped); Average Fuel Consumption; To Turn off Fuel Consumption Indicator Display

Black plate (144,1)
北米Model "A8170BE-A" EDITED: 2011/ 6/ 24
3-28 Instruments and controls
temperature, the display switches to the
outside temperature indication and flashes
for 5 seconds before r eturning to its
original indication.
NOTE
The outside temperature indication
may differ from the actual outside
temperature. The road surface freeze
warning indication should be treated
only as a guide. Be sure to check the
condition of the road surface before
driving.
& Current fuel consumption (if
equipped)
This indication shows the rate of fuel
consumption at the present moment.
NOTE
The indicated values vary in accor-
dance with changes in the vehicle’s
running conditions. Also, the indicated
values may differ slightly from the
actual values and should thus be
treated only as a guide.
& Average fuel consumption
1) U.S.-spec. models
2) Except U.S.-spec. models
This indication shows the average rate of
fuel consumption since the trip meter was
last reset.
When either of the trip meter indications is
reset, the corresponding a verage fue l
consumption value is also reset.
NOTE
. The indicated values vary in accor-
dance with changes in the vehicle’s
running conditions. Also, the indicated
values may differ slightly from the
actual va lues and should thus be
treated only as a guide.
. When either trip meter indication is
reset, the average fuel consumption
corresponding to that trip meter indica-
tion is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).
& To turn off fuel consumption
indicator display
The fuel consumption indicator displ ay
can be turned off.
To turn off this display, turn the ignition
switch to the “LOCK” position and press
the “+” button adjacent to the information
display for approximately 5 seconds. The
information display and the clock display
will blink for 3 seconds and then the fuel
consumption display will turn off.
To restore the indicator, once again press
the “+” button for approximately 5 sec-
onds.
NOTE
. The initial display setting of the fuel
consumption indicator of your vehicle