Subaru 2012 Forester - Brake Fluid

Black plate (371,1)
北米Model "A8170BE-A" EDITED: 2011/ 6/ 24
2. Check the fluid level of the reservoir.
When the fluid is hot after the vehicle has
been run: Check t hat the oil level is
between “HOT MIN” and “HOT MAX” on
the surface of the reservoir.
When the fluid is cool before the vehicle is
run: Check that the oil level is between
“COLD MIN” and “COLD MAX” on the
surface of the reservoir.
3. If the fluid level is lower than the
applicable “MIN” line, add the recom-
mended fluid as necessary to bring the
level between the “MIN” and “MAX” line.
If the fluid level is extremely low, it may
indicate possible leakage. Consult your
SUBARU dealer for an inspection.
WARNING
Be careful not to burn yo urself
because the fluid may be hot.
CAUTION
. When power steering fluid is
being added, use only clean fluid,
and be careful not to allow any
dirt into the tank. Never use
different brands of fluids to-
gether.
. Be careful not to spill power
steering fluid when adding it. If
power steering fluid touches the
exhaust pipe, it may cause a bad
smell, smok e, and/or a fire. If
power steering fluid gets on the
exhaust pipe, be sure to wipe it
off.
& Recommended fluid
Refer to “Fluids” F12-9.
Brake fluid
& Checking the fluid level
1) “MAX” level mark
2) “MIN” level mark
Check the fluid level monthly.
Check the fluid level on the outside of the
reservoir. If the level is below “MIN”, add
the recommended brake fluid to “MAX”.
Use o nly bra ke fluid from a sealed
container.
WARNING
. Never let brake fluid contact your
eyes because brake fluid can be
harmful to your eyes. If brake
fluid gets in your eyes, immedi-
ately flush them thoroughly with
Maintenance and service 11-23
– CONTINUED –
11