Black plate (124,1)
北米Model "A8170BE-A" EDITED: 2011/ 6/ 24
3-8 Instruments and controls
2. Press the trip knob to show “ ” or
“
” on the trip meter display. The display
can be switched as shown in the following
sequence by pressing the trip knob.
*: “ ” or “ ”, and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter needles/gauge of your vehicle
has been set for activation “
” at the
time of shipment from the factory.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
Type A
1) Trip knob
Type B
1) Trip knob
To Next Page