Black plate (292,1)
北米Model "A8170BE-A" EDITED: 2011/ 6/ 24
7-34 Starting and operating
. Push the “CANCEL” button.
. Depress the brake pedal.
. Depress the clutch pedal (MT models).
. Shift the select lever into the “N”
position (AT models).
. Shift the shift lever into neutral position
(MT models).
The cruise control set indicator light on the
combination meter turns off when the
cruise control is canceled.
To resume the cruise control after it has
been temporarily canceled, push the
“RES/ACC” button. The vehicle will return
to the original cruising speed automati-
cally and the cruise control set indicator
light on the combination meter will illumi-
nate.
NOTE
If the vehicle speed has decreased
below approximately 20 mph (32
km/h), the previously set cruising
speed is canceled completely and
resetting of the cruising speed is
required.
& To turn off the cruise control
There are two ways to turn off the cruise
control:
. Push the “CRUISE” main switch button
again.
. Turn the ignition switch to the “Acc” or
“LOCK” position (but only when the
vehicle is completely stopped).
& To change the cruising speed
! To increase the speed (by button)
Push the “RES/ACC” button and hold it
until the vehi cle rea ches the d esired
speed. Then, release the button. The
vehicle speed at that moment will be
memorized and treated as the new set
speed.
When the difference between the actual
vehicle speed and the set speed is less
than 4 mph (6.8 km/h), the set speed can
be increased 1 mph (1.6 km/h) each time
To Next Page
Loading...
