Suez CheckPoint Pharma - Menu Overview

CheckPoint Pharma and CheckPoint
e
Operation and Maintenance Manual
SUEZ © 2018 41 of 112 DLM 97200-03 EN Rev. A
Chapter 2 — Menu Overview

Older models of the CheckPoint Sensors only include two 4-20 mA outputs.
*Optional menu features available when I/O configuration is present.
Mode
I/O
Setup
Maintenance
Calibration
Analog Outputs*
Output Rate
Diagnostics
TOC
Analog Output 1
Password
Pump
TOC Cal
Enable/Disable Analog 1
Enable/Disable Password
Lamp
TOC Autozero
Set Parameter
Change Password
Conductivity Board
Set Schedule
Set Range
Clock
Save Service Data
Run Autozero
Set Standby
Set Date
4-20 mA*
TOC Match
Set Error
Set Time
Alarms*
Conductivity
Set Warning
Units of Measure
Consumables
Cond Cal
Analog Output 2
Conductivity/Resistivity/Raw Conductivity
Lamp Install
Cond Match/Res
Match
Enable/Disable Analog 2
Instrument Name
Pump Install
Battery Status
Flow Rate
Set Parameter
Change Name
View Errors
Remove
Grab Sample
Set Range
LCD Contrast
Sys Constants
Set Standby
Language
View Constants
Set Error
Inverse Display (F1)
Restore Constants
Set Warning
Analog Output 3

Enable/Disable Analog 3
Set Parameter
Set Range
Set Standby
Set Error
Set Warning
Binary Input*
Disable
Activate Low/High
Alarms*
Alarm 1
Disable Alarm 1
Setup Alarm 1
Alarm 2
Disable Alarm 2
Setup Alarm 2
ModBus
Enable/Disable ModBus
Set IP Address
Use DHCP/Enter Fixed IP (F1)
Set Net Mask
Connect (F1)