CheckPoint Pharma and CheckPoint
e
Operation and Maintenance Manual
SUEZ © 2018 61 of 112 DLM 97200-03 EN Rev. A
Starting and Stopping Analysis
To start analysis, press the button. When the Sensor is in On-Line Mode, a flashing triangle
displays in the upper right corner of the screen. A confirmation screen is displayed before starting
analysis. Press the button followed by F1 to stop analysis.
If a printer has been installed, the CheckPoint will print the results of each measurement.
To start the Sensor in Grab mode, refer to the Grab Sample Mode section on page 62.
Main Screen Options
To access the Main screen, press the Menu button on the touch screen. The Main screen provides
access to the Sensor’s settings and maintenance features. When a menu has more options than can
be displayed on one screen, an up or down arrow displays on the right side of the screen. Use the
button to scroll the highlight pointer on the left side of the screen through the options. When an
error has been recorded, the E icon displays at the top of the screen.
Press the Function key that corresponds to the path you want to follow. To exit the Main screen,
simply press any button on the touch screen.
Figure 24: Main Screen
Mode Menu Options
The Mode screen provides access to the Sensor’s sampling modes and calibration features. To
access the Mode screen, from the Main screen, press F1.
Calibration Mode
To display the Calibration screen, access the Main screen and then press F1 twice. Under the
Calibration option, there are three main functions available. Consult the Calibration Chapter for details
on these functions.
To Next Page
Loading...