Sumitomo Bevel Buddybox 4 User Manual

Manual BBB4_ENG_01_2016_991301 11
Installation onto Driven Shaft, continued
Taper-GripBushing
Clean Driven
Shaft
2
Loosen socket head cap screws.
3
Remove (unscrew) Taper-Grip bushing from the unit.
4
Clean all grease,oil and/or anti-seize paste from the driven shaft. Failure to do so
could result in damage to shaft.
Slide Taper-Grip bushing onto driven shaft.
5
Inspect and test Taper-Grip bushing on shaft.
• Checkshaftforburrs,corrosion,orwarpage.Repairorreplaceshaftas
necessary.
•  Slidebushingbackandforthalongshaft,checkingforsurfaceirregularitiesandt.
• Verifybushingissizedcorrectlyfortheshaftdiameter.

Sumitomo Bevel Buddybox 4 Specifications

General

Brand	Sumitomo
Model	Bevel Buddybox 4
Category	Engine
Language	English