Sumitomo Bevel Buddybox 4 - Page 13

12 Manual BBB4_ENG_01_2016_991301
Installation onto Driven Shaft, continued
Taper-GripBushing
Apply thin layer of
anti-seize paste to male
threads of bushing only.
Do not apply anti-seize
paste to the female
threads in the hub.
6
Remove Taper-Grip bushing from driven shaft.
7
Apply a thin layer of anti-seize paste to the male threads of the Taper-Grip
bushingonly.
Ensure that the anti-seize paste does not enter the Taper-Grip
bushingbore.
Do not apply anti-seize paste to the female threads in the hub.
8
Screw Taper-Grip bushing into BBB4 leaving approximately1mmgapbetweenthe
bushingangeandthrustcollar.
Donotapplygrease,oil,oranti-seizepastetothedrivenshaftor
thebushingborebefore placing the unit onto driven shaft. Use of these
friction-minimizing products will adversely affect the ability of the unit to
transmit torque.
CAUTION: The BBB4 must be externally supported prior to insertion of
driven shaft into bushing. External support MUST be maintained until all
bushing socket head cap screws have been tightened to the appropriate
operational torque.
9
Mount or slide the BBB4 onto the driven shaft to the desired location.
Do not rock or pry the unit.