9-3
9.Troubleshooting｜Error message list
9. Troubleshooting
Error message Possible cause Troubleshooting Refer to
The splicer could
not detect the left
(right) fiber.
The fiber is not loaded in an
appropriate position.
Make sure that the left (right) fiber
is placed in the correct position of
the splicer.
▸P.2-14
Inserting
fibers into the
splicer
There is dust on the V-
groove and bare fiber pad.
Clean the V-groove and bare fiber
pad.
▸P.3-1
Cleaning V-
grooves, P.3-2
Cleaning LEDs
and bare fiber
pads
The splicer failed
to adjust the arc
gap of the left
(right) fiber.
There is a foreign object in
the screen.
Clean the microscope lens
protection glass and LEDs.
▸ P.3-2
Cleaning LEDs
and bare fiber
pads, P.3-3
Cleaning lens
protection
glass
There is dust on the V-
groove and bare fiber pad.
Clean the V-groove and bare fiber
pad.
▸P.3-1
Cleaning V-
grooves, P.3-2
Cleaning LEDs
and bare fiber
pads
The cleave angle of
the left (right) fiber
exceeds the
allowable limit.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
OK
Bare fiber pad
NG
V-groove
Microscope lens protection glass
LED
V-groove
Bare fiber pad
To Next Page
Loading...
