9-4
9.Troubleshooting｜Error message list
9. Troubleshooting
Error message Possible cause Troubleshooting Refer to
A lip is observed
on the left (right)
fiber end.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
A chip is observed
on the left (right)
fiber end.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
The splicer failed
to adjust the focus.
There is a foreign object in
the screen.
Clean the microscope lens protection
glass and LEDs.
▸ P.3-2
Cleaning LEDs
and bare fiber
pads, P.3-3
Cleaning lens
protection
glass
There is dust on the V-
groove and fiber clamp.
Clean the V-groove and bare fiber
pad.
▸P.3-1
Cleaning V-
grooves, P.3-2
Cleaning LEDs
and bare fiber
pads
There is dust on the fiber.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
The splicer failed
to align the left
(right) fiber.
▸Continued to the
next page.
There is dust on the fiber.
Cleave the left (right) fiber again.
▸Instruction
manual that
came with
the cleaver
you use.
Dust
OK
OK
Dust
Microscope lens protection glass
LED
Bare fiber pad
V-groove
To Next Page
Loading...
