The “Freeze” button will be replaced by the “Store” and “Undo”
buttons. The “Store” button will be automatically selected (indicated
by a Green background – see Figure 8-9).
•
Press “Store” to store the data or “Undo” to unfreeze the data and
return to continuous measurement..
Figure 8-9 Store Limit Set 1 Readings
If the “Store” button is pressed:
-
The “Store” and “Undo” buttons will be replaced by the “Freeze”
button.
-
The “Freeze” button will be automatically selected.
-
The number “1” (corresponding to the Limit Set and data buffer
selected) will appear in the toolbar indicating that the data is
stored in data buffer 1.
-
Limit Set 2 will be applied automatically and the “Toggle Limit
Sets” button will change accordingly.
Note:
If the “Undo” button is pressed the “Store” and “Undo” buttons will be
replaced by the “Freeze” button. The “Freeze” button will be
automatically selected. Limit Set 1 will continue to be applied.
•
Take the Limit Set 2 gas measurements as outlined in 8.5: „Free
Measurement Test Procedure‟.
•
Press the“Freeze” toolbar button.
Figure 8-10 Freeze Limit Set 2 Readings
The “Freeze” button will be replaced by the “Store” and “Undo”
buttons. The “Store” button will be automatically selected (indicated
by a Green background – see figure below).
49
To Next Page
Loading...