Sun Microsystems Netra - Page 162

C-2 Netra Internet Server 3.1 User’s Manual—September 1996
C
2. Physically connect the Netra server to the LAN, and attach the TTY
terminal.
Refer to the Netra Internet Server Hardware Installation Manual for
instructions.
3. Obtain the following configuration information for your site:
• System Defaults (see Chapter 19, “Netra System Administration”)
• LAN interface information: host address and netmask for a TCP/IP
network, or network number and frame type for an SPX/IPX network
(see Chapter 12, “Local Area Network Administration”)
• Host name for your Netra server (see Chapter 19, “Netra System
Administration”)
• System administrator alias members (see Chapter 19, “Netra System
Administration”)
• Root password (see Chapter 18, “Root Password Administration”)
• Administration Web Server password (see Chapter 15, “Administration Web
Server”)
▼ To Run the Setup Script
1. Power on the Netra server and the TTY terminal.
2. At the NewNetra console login prompt, enter setup.
Note that an unconfigured Netra server uses the name NewNetra.
3. At the Password prompt, enter setup again.
The following screen is displayed:
This program generates a configuration file
for the local area network interface.
Values shown in square brackets are the default values.