Initial Configuration Using TTY C-3
C
4. Enter the number that corresponds to the network interface in your server:
5. Enter the number corresponding to the type of network you have:
6. Enter information for your network type as follows.
• If you typed 1 for a TCP/IP network:
a. Enter the Netra server’s LAN host address:
b. Enter the netmask:
The following interfaces are available:
1) Lance Ethernet Port 0
2) Lance Ethernet Port 1
Enter the number corresponding to the interface
to be configured [1]:
The following types of networks are available:
1) TCP/IP
2) Novell (SPX/IPX)
Enter the number corresponding to the network type [1]:
Enter the local area network host address for the
Netra server:
Enter the local area network netmask for the
Netra server [255.255.255.0]:
To Next Page
Loading...
