Initial Configuration Using TTY C-5
C
c. Confirm that the entered information is correct:
The following is displayed:
▼ To Complete the Initial Configuration from a Client PC
1. Start a browser on a client PC on the LAN.
2. Open the following URL in the browser:
• If you have a TCP/IP network, open:
• If you have an SPX/IPX network, open:
3. Enter setup for the User ID; then enter setup for the Password.
The Netra Welcome page is displayed.
The following configuration information has been entered:
Interface: your interface
Frame type: your frame type
Network number: your network number
Select from the following options:
1) Configure le0 with these values.
2) Discard these values and input new values.
3) Discard these values and exit.
Enter an option [1]:
Lance Ethernet Port 0 has been configured SPX/IPX operation.
Frame type: your frame type
Network number: your network number
http://netra_host_address:81
http://NewNetra:81
To Next Page
Loading...
