Performing the Initial Configuration 4-7
4
▼ To Create a Partial Configuration Diskette
1. Insert the Utilities diskette into the PC diskette drive.
2. Access drive A:
3. Run the following program:
The following is displayed:
4. Enter the name of the Netra server.
5. Enter the number that corresponds to the network interface in your server:
c:\ a:
a:\ config
This program generates a configuration file
for the local area network interface.
Values shown in square brackets are the default values.
Enter the Host Name for the Netra Server:
The following interfaces may be available on your Netra server:
1) Lance Ethernet
2) Quad Ethernet
3) Fast Ethernet
4) Token Ring
5) Fast Ethernet 100baseT
Enter the number corresponding to the interface
to be configured [1]:
To Next Page
Loading...
