4-8 Netra Internet Server 3.1 User’s Manual—September 1996
4
6. Enter the Ethernet port that you are using to connect the Netra server to
the local area network:
7. Enter the number corresponding to the type of network you have:
8. Now enter information for your network type as follows:
• If you typed 1 for a TCP/IP network:
a. Enter the Netra server’s local area network host address:
b. Enter the netmask:
The information you entered is saved on the diskette. This diskette now
contains partial configuration information for your Netra server.
c. Go to Step 9.
• If you typed 2, for a Novell (SPX/IPX) network:
a. Enter the IPX network number:
See Chapter 11 for more information on SPX/IPX network numbers and
frame types.
Which port are you using on the Netra to connect to the local area
network? [0]:
The following types of networks are available:
1) TCP/IP
2) Novell (SPX/IPX)
Enter the number corresponding to the network type [1]:
Enter the local area network host address for the
Netra server:
Enter the local area network netmask for the
Netra server [255.255.255.0]:
Enter the IPX network number in hexadecimal format:
To Next Page
Loading...
