Performing the Initial Configuration 4-9
4
b. Enter the number for the frame type you are using:
The information you entered is saved on the diskette. This diskette now
contains partial configuration information for your Netra server.
9. Eject the diskette from the drive.
10. Make sure your Netra server is connected to the LAN.
Refer to your Netra hardware installation manual for this procedure.
11. Insert the diskette with partial configuration information in the Netra
diskette drive.
12. Power on the Netra server.
▼ To Complete the Initial Configuration
1. Start a browser on a client PC on the LAN.
2. Open the following URL in the browser:
• If you have a TCP/IP network, open:
• If you have an SPX/IPX network, open:
A password window is displayed.
The following frame types are available:
1) Ethernet_802.2
2) Ethernet_802.3
3) Ethernet_II
4) Ethernet_snap
Enter the number corresponding to the frame type being used [1]:
http://netra_host_address:81
http://hostname:81
To Next Page
Loading...
