2-12 Sun Fire V20z and Sun Fire V40z Servers—User Guide • March 2005
Console
Redirection
Additional setup to configure console. Options include:
• COM port address: If enabled, the console uses a port on
the motherboard. Options include: Disabled, On-board
COM A, On-board COM B.
On-board
COM A
• Console connection: Indicates whether the console is
connected directly to the system or through a modem.
Options include: Direct and Modem.
Direct
• Baud rate: Enables the specified baud rate. Options
include: 300, 1200, 2400, 9600, 19.2K, 38.4 K, 57.6K, 115.2
K.
9600
• Flow control: Enables flow control. Options include:
None, XON/XOFF, CTS/RTS.
None
• Console type: Enables the specified console type. Options
include: VT100, VT100 8 bit, ANSI 7 bit, ANSI, VT100
plus, UTF8.
vt100 plus
• Continue CR after POST: Normally, console redirection is
off before the OS loads. Set this item to On to
troubleshoot the BIOS boot problems. Note: the OS
loader typically interrupts console redirection once it
starts.
Options include: On and Off.
On
TABLE 2-3 BIOS Advanced Menu (Continued)
Menu Option Description Default
To Next Page
Loading...
