53
No. Function StepRange
Initial value
[ Caution ]
If the specific items of the parameter are changed carelessly, they could break down or damage the machine, so the user must be
well-trained before using it.
Selection of start B/T operating conditions 1 0 : B/T stop function selected
50 ( 0 : if pedal is released during back tack, it will stop) 1 : B/T work completion
( 1 : if pedal is released during back tack, the work will still be completed) 2 : B/T exact stitch performance
( 2 : it will perform the exact amount of back tack stitches)
51 Selection of end back tack performance condition 0 0/1 1= exact stitch performance
(It will perform the exact amount of stitches for end back tack )
52 Back tack initial first stitch speed during back tack exact performance 200spm 20~1000 10spm
53 Change between B/T and switch with buttons A or B during sewing 0 0/1 1= Select with button B
0 : Only B/T operates
1 :
Lift and drop needle plate with one movement.
54 Selection of button A function 2 2 : Lift needle plate with one movement.
Drop needle plate with two movements
3 : Slow performance when stopped
(1/2 stitch speed)
0 : B/T delete insertion
55 Selection of Button B function 0 1 :
Lift and drop needle plate with one movement
2 : Slow performance when stopped
(1/2 stitch speed)
3 : Only B/T operates
56 Selection of speed during manual back tack during sewing 0 0/1 0 : current sewing speed
1: initial reverse speed
57 NOT USED
58 Thread Trimming Sequence Selection of SunStar Chain Stitch Machine 1 0/1 1
59
Thread Trimming Sequence Selection of other Company chain Stitch Machine
0 0/1 1
60 Selection of reverse rotation after trimming 0 0/1 1:selection of reverse direction
61
Reverse rotation distance when selecting reverse rotation after thread trimming
20degree 0~250 1degree
62 When machine stops fix pulley (When machine stops fix the motor by force) 0 0/1 1: fix when machine stops
63 Power to fix the A number 62 Pulley 40 10~100 1
64 Distance recovered after fixing A number 62 Pulley and rotating it by force 20degree 10~100 1degree
1 0/1 1 : clockwise
65 Select the motor rotating direction ( ) 0 : counterclockwise
66 Target speed : If this speed is reached or passed, a signal saying 1000spm 40~9960 40spm
"Target speed has been reached will appear.
67 Delay start setup 0 0/1
0=normal start
1=Delay start
68 Delay start time duration setup 3 3~250 1×100[ms]
69
Setup of needle bar's stop at the lowest position after trimming when the
0 0/1
0=disabled
pedal is pressed 1=enabled
70
Setup of the duration of needle bar's stop at the lowest position after
100 100~250 1[ms]
trimming when the pedal pressed
71 Fixing of edge sensor 0 0/1
0=disabled
1=enabled
72 Detection time of high-voltage error 10
2 1020[ms]
2 [ms]
73 Use of the upper trimming device 0 0/1
0=disabled
1=enabled
clockwise /counterclockwise
CCW CW
To Next Page
Loading...
Need help?
General
