SunSynk SUNSYNK-8K-SG01LP1 - Factory Reset and Lock Code

SINGLE PHASE HI 8kW | User Manual45
Set a number in the auto dim box to dim the
LCD after a number of seconds.
How to set the auto dim:
How to turn the beep on or o:
Check or uncheck the beep box and the press
OK to congure it as you prefer.
5.8.3. Factory Reset and Lock Code
To access the Settings, click on the gear icon on the right top of the menu.



      
0.0
kWh
0.0
kWh
0.0
kWh
0.0
kWh
0.0
kWh
0.0
kWh
85%
BATTERY IN/OUT MPPT. GRID.

 
SOLAR/TURBINE AC load
Battery Grid
 Reset status.
 Whether the ‘lock code’ is used or not.
What this page displays:
 Reset the inverter to the factory settings.
 System diagnostics.
 Change or set the ‘lock code’.
What you can do from this page:
Factory Reset: Reset all parameters of the inverter
Lock out all changes: Enable this menu to set parameters before the unit is locked and cannot be reset.
*Before performing a successful ‘Factory Reset’ and locking the systems, the user must enter a
password to allow the setting to take place. The password for ‘Factory Reset’ is 9999 and for
lockout is 7777.
System self-check: Allows the user to conduct a system diagnosis. After ticking this item, it needs input the
password. The default password is 1234
Test mode (only for engineers): For engineers to conduct tests.