SunSynk SYNK-16K-SG01LP1 - TECHNICAL SPECIFICATIONS; Protection

SUNSYNK MAX | Installer Manual10
TECHNICAL SPECIFICATIONS
Model SYNK-16K-SG01LP1
Battery Input Data
Battery Type Lead-acid or Lithium-ion
Battery Voltage Range 40~60V
Max. Charge Current 290A
Max. Discharge Current 290A
Charging Curve 3 Stages/Equalization
External Temperature Sensor Yes
Charging Strategy for Li-Ion Battery Self-Adaptation to BMS
PV String Input Data
Max. DC Input Power 20800W
Max PV Input Voltage 370V (125~500V)
MPPT Range 150V~425V
Start-up Voltage 125V
PV Input Current 26A + 26A + 26A
Max. PV Isc 44A + 44A + 44A
No. of MPPT / Strings Per MPPT 3 / 2+2+2
AC Output Data
Max. On-Grid AC Power 16000W
Max. O-Grid AC Power 17600W
Max. AC Output Apparent Power 16000VA
Peak Power (o-grid) 2 times of rated power, 10 S
AC Output Rated Current 72.7/69.6A
Max AC Current 80/76.5A
Max Continuous AC Passthrough 100A
Power Factor 0.8 leading to 0.8 lagging
Output Frequency and Voltage 50Hz/60Hz; 220/230Vac (single phase)
Grid Type Single-Phase
Current Harmonic Distortion THD < 3% (of nominal power)
DC Current Injection < 0.5% In
Eciency
Max. Eciency 97.60%
Euro Eciency 96.50%
MPPT Eciency > 99%
Protection
Integrated
PV Arc Fault Detection, PV Input Lightning Protection, Anti-islanding
Protection, PV String Input Reverse Polarity Protection, Insulation
Resistor Detection, Residual Current Monitoring Unit, Output Over
Current Protection, Output Shorted Protection
Surge Protection DC Type II / AC Type II
Over Voltage Category DC Type II / AC Type III