SUNSYNK MAX | Installer Manual51
Program Charge & Discharge Times
To set ‘Charge’ and ‘Discharge’ times, click on the ‘System Mode’ icon after clicking on the gear icon.
16000W
16000W
16000W
16000W
16000W
16000W
16000W
20W
1. Zero Export: Tick this box to not export power back to the grid (the CT coil will detect power owing
back to the grid and will reduce the power of the inverter only to supply the local load).
2. Solar Export: Tick this box if you wish to export your solar power back to the grid.
3. Limit to Load Only: Tick this box if you only want to supply power to the load side of the inverter.
4. Grid Trickle Feed: Is the amount of power owing from the grid to the inverter. Set this value to ’20 -
100W’ to instruct the inverter to always take the prescribed amount of power from the grid to minimise
the tripping of sensitive pre-paid electricity meters if ‘Reverse Power Detection’ occurs.
5. Inverter Power Limiter: This controls the maximum overall power, both to the ‘Load’ and ‘Grid’ ports
combined. It is set to Low if an ‘over-current’ fault occurs.
6. Priority Load: Tick this box if you wish to set the solar panels to give power to the ‘Load’. If you untick
this box, the solar will send power to charge the batteries.
What this page displays:
To Next Page
Loading...
Need help?
General