Suntex EC-4110 - 6.3 Mode

6.3 Mode
Enter setup of “Mode”. Select between “Conductivity (Cond)” or “Resistivity
(Res)” measurement. If select “Conductivity”, then the range limit needs to be selected
from AUTO, 20.00S, 200.0S, 2000S, 20.00mS or 200.0mS.
Enter ”Temperature” Setup
Press to confirm it.
Press to confirm it.
Select “Res”.
Press to confirm it.
Select “Cond”.
Press to confirm it.
Select “mS/cm”.
Press to confirm it.
Select “S/cm”.
Press to confirm it.
Select “AUTO”.
Press to confirm it.
Select “GEAR”.
Press to confirm it.
Select “GEAR”.
кс