6.4 Temperature
Enter setup of “Temperature” to select temperature compensation mode. Select from
NTC(NTC 30K), PTC(PT 1K) or MTC(Manual adjustment), or you may press &
simultaneously to back to default setting. In the measurement mode, if selecting MTC
for temperature compensation mode, you may press or to adjust MTC
temperature value.
If necessary, compare with
the actual temperature value
tested by standard
thermometer.
Press or to
input the modified value.
Press to confirm it.
Press to confirm it.
Press to confirm it.
Enter “Compensation” Setup
Press
or to select
Press
or to select
Press to confirm it.
Use standard thermometer to test
the actual temperature of the
solution, and press or
to input the correct temperature
value.
кт
To Next Page
Loading...
