Supermicro X11SAE/X11SAE-F Motherboard User’s Manual
4-24
• Model number of drive and capacity
• Software Preserve Support Information
Port 0 ~ Port 7 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to ini-
tialize the device. The options are Enabled and Disabled.
Port 0 ~ Port 7 SATA Device Type
Use this item to specify if the SATA port specied by the user should
be connected to a Solid State drive or a Hard Disk Drive. The options
are Hard Disk Drive and Solid State Drive.
PCIe/PCI/PnP Configuration
The following information will display:
• PCI Bus Driver Version
• PCI Devices Common Settings:
PCI Latency Timer
Enter the value to be programmed into the PCI Latency Timer Register.
The options are 32 PCI Bus Clocks, 64 PCI Bus Clocks, 96 PCI Bus
Clocks, 128 PCI Bus Clocks, 160 PCI Bus Clocks, 192 PCI Bus Clocks,
224 PCI Bus Clocks, and 248 PCI Bus Clocks,.
PCI PERR/SERR Support
Select Enabled to allow a PCI device to generate a PERR/SERR number
for a PCI Bus Signal Error Event. The options are Disabled and Enabled.
Above 4G Decoding (Available if the system supports 64-bit
PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space
above 4G Address. The options are Enabled and Disabled.
SLOT1 PCI 33MHz OPROM
Use this feature to select which rmware type to be loaded for the add-on
card in this slot. The options are Disabled, Legacy, and EFI.
SLOT2 PCI 33MHz OPROM
Use this feature to select which rmware type to be loaded for the add-on
card in this slot. The options are Disabled, Legacy, and EFI.
To Next Page
Loading...
Need help?
General
