Sutron Corporation Satlink Operations & Maintenance Manual, Rev 8.04.2 11/3/2016 pg. 66
7.2.3. Working with a Password Protected Station
If LinkComm is used to connect to a password protected station, LinkComm will automatically
prompt for a password.
When sending a message to a password protected station, the first line of the message must
have the login command LOGIN=XXX, where XXX is the password.
7.2.4. Logging Out
Logging out is accomplished by one of the following:
Disconnect with LinkComm
Type EXIT in the command line
Disconnect the USB cable
Power down the unit
To Next Page
Loading...