Sutron Corporation Satlink Operations & Maintenance Manual, Rev 8.04.2 11/3/2016 pg. 97
Measurement M1 STAGE set to 12.000
04/18/2012,13:19:49,STAGE,8.119
04/18/2012,13:19:49,Calibration,1
04/18/2012,13:19:49,STAGE,12.000
9.10. Multiple Measurements Using the Same Sensor
You can set up multiple measurements with the same input. For example, to log the daily rainfall
and the rainfall during the last hour, set up two measurements: one as a precipitation rate with
an interval of one hour, and another as precipitation rate with an interval of one day.
To log the daily temperature and the hourly temperature, only one physical temperature sensor
is needed. Set up two measurements with the same setup; change the Measurement Interval and
the Averaging Time and use a different Label for each. One would happen once a day
(Measurement Interval 24 hours, Averaging Time 24 hours), and the other once an hour
(Measurement Interval 1 hour, Averaging Time 1 hour). It would be a good idea to set up the
sampling Interval to one minute for both sensors in order to save power (See page 71).
If two separate measurements are scheduled to measure the same sensor at the same time (as
they will in the examples above), only one reading of the sensor is made and the result is shared
by both measurements.
To Next Page
Loading...