Sutron Corporation Satlink Operations & Maintenance Manual, Rev 8.04.2 11/3/2016 pg. 57
You can also upgrade the firmware via USB. See section 6.15.3 Update the Firmware via USB
Thumb Drive.
5.12.6. Setting to Factory Defaults
Setting the station to factory defaults will permanently erase all setup and status. The setup will
be set to defaults. To set Satlink to factory defaults, press the Factory Defaults button on the
Diagnostics tab and answer “Yes” to the prompt for confirmation.
5.12.7. Rebooting Satlink
Clicking the Reboot button on the Diagnostics tab will have LinkComm issue the reboot
command to Satlink. Satlink will perform a software reset. LinkComm will then disconnect from
Satlink.
If you are issuing the command remotely, please note that Satlink will need a minute to get back
on the internet before it is ready to talk again.
5.13. Password Menu
LinkComm provides Password related items in the menu that can be used to log in, change the
password, and log out. LinkComm will prompt for a password when it is needed.
For details on password operation, please see the Error! Reference source not found. section.
To Next Page
Loading...