Suunto Vector - BUTTON FUNCTIONS

10
BUTTON FUNCTIONS
Four buttons are used to operate the Wristop Computer: [Mode], [+] (ON/OFF), [-] (Fast Bearing), and
[Select].
THE [MODE] BUTTON
Is located on the top right of the Wristop Computer.
 In the main mode level, pressing the [Mode] button allows the user to select or move from one
mode or function to the next (TIME, ALTI, BARO, COMP).
 In the sub mode level, pressing the [Mode] button returns the user to the main mode level.
 In the setup process, pressing the [Mode] button accepts the changes or preferences. Pressing the
button again will return the user to the main mode level.
 Pressing the button for 2 seconds activates the backlight feature.
THE [+] BUTTON
Is located on the bottom right of the Wristop Computer.
 In the setup process, pressing the [+] button changes or scrolls the value upward.
 In the timing and logbook functions, this button can act as a start/stop (or On/Off) button.
THE [-] BUTTON
Is located on the bottom left of the Wristop Computer.
 In the setup process, pressing the [-] button changes or scrolls the value downward.
 For the Navitec, Vector and X-Lander models this button is also known as the Fast Bearing button.
Pressing the [-] button in any of the main modes will quickly display the compass mode, showing
either the normal compass or bearing tracking feature (depending on what display has been chosen
in the compass mode).
 For the Altimax model, this button is also called the Fast Cumulative button. Pressing the [-] button
in any of the main modes will quickly display the cumulative information of the current logbook
recording.
Note: Details of this feature can be located on Page 33 of this manual.