32
The fifth display shows the time duration of recording information in the particular logbook that is
being viewed.
Field 2 displays the total time of the log ; and
Field 3 displays the text dUr along with the text Log Book to the left.
Note: If the logbook is recording, based on the interval chosen the logbook will record up to that
particular time period. Once the time period has been reached the Wristop Computer, will alert the user
that the logbook recording has expired (known as a timeout). For setting the logbook interval refer to
Setting the Altimeter on Page 3-3.
The timeouts are as follows:
Logbook intervals Maximum recording time
20 second 10 hours
1 minute 12 hours
10 minute 7 days
60 minute 10 days
How to Start and Stop a Logbook
For the Vector and X-Lander models:
In the Altimeter main mode or the difference measurement sub mode, PRESS the [+] button. A beep will
be heard and the flashing text Log Book will appear in Field 3 to indicate the start of the recording.
Note: For the Vector and X-Lander models,while in the recording phase of the current logbook, the user
will be unable to view this data. The user can view this data only after the recording session has stopped,
but previously recorded logbooks can be viewed at any time.
The recording can be stopped by pressing the [+] a second time. A beep will be heard and the Log
Book text will be removed from Field 3 indicating recording has stopped.
Note: In order to prevent accidental starts/stops of a logbook, the Vector or X-Lander models should be
in another function other than the altimeter mode. If the logbook is activated the logbook will continue
to recorded even if the Vector or X-Lander is in another mode.
To Next Page
Loading...
