Suunto Vector - How to Start the Altitude Difference Measurement; 24-HOUR MEMORY MODE

30
The running time is displayed up to 39 hours and 59 minutes; after which three dashes (-:--) appear on
the display in Field 3. If the user allows the difference measurement sub mode to remain on visual
display continuously for 12 hours, the Wristop Computer will automatically return to the main time
mode.
This mode does continue in the background and allows the user to move to other modes and at the
convenience of the user can return to this sub mode to display the current status.
Note: The difference measurement mode is a relative measurement. Any change in the reference altitude
during the altitude difference measurement will effect the measured altitude. We recommend that the
reference altitude always be checked and set again prior to beginning a new measurement.
How to Start the Altitude Difference Measurement
1. PRESS the [Select] button and hold for 2 seconds. Located in Field 1 is the text SET; located in Field
2, zero will begin to flash.
2. PRESS the [Mode] button to accept the flashing zero and start the difference measurement.
If the user does not desire to begin the difference measurement, PRESS either the [+] or the [-] button to
toggle to the current altitude then PRESS the [Mode] button to exit the setup program.
Note: If the user does not press any button for 1 minute in the setup mode, the display will return to the
main mode without zeroing the altimeter.
24-HOUR MEMORY MODE
In the Altimeter mode, PRESS the [Select] button twice to enter this sub mode.
In the 24-hour memory mode:
 Field 1 displays the vertical ascent or descent rate;
 Field 2 displays the current altitude in increments of 5 meters or 10 feet depending on the unit of
measure selected; and
 Field 3 displays the particular hour and to the left the text memory.
 The Outer Circumference displays graphically the altitude in hundreds of meters or feet over a full
thousand where one complete circle is equivalent to 1000.
To view the information compiled in the 24-hr memory:
1. PRESS the [-] button to scroll back down in increments of one hour and view the vertical ascent/
descent rate and the altitude for that particular hour.