44
mode, the segment display increases clockwise, but if you are in a mode that shows you differences
(such as vertical ascent/descent), all decreasing values go counterclockwise from the center position, and
all increasing values go clockwise. So, it is minus to the left (counterclockwise), and plus to the right
(clockwise).
Why are there two symbols above the Mode Indicator Bar and what do they
mean?
The left-hand symbol indicates that the altitude alarm is activated and the right-hand symbol indicates
that one, two, or three daily alarms are activated.
TIME
Why do the segments on the circumference increase and decrease when I am in
the Time mode?
The main function of the segments is related to the Compass mode, where a division into 36 segments is
necessary due to the 360-degree scale of a compass. In the Time mode, the segments show the
advancement of seconds. Because the number of seconds differs from the number of degrees, it is
impossible for the segments to be consecutively lit up; they now light up or extinguish, thereby marking
the passing of every second.
What is the longest time I can set in the timer?
The maximum range of the countdown timer is 23 hours 59 minutes and 59 seconds.
ALTIMETER
How do you clear the logbook?
The logbook is self-erasing and cannot be cleared by the user.
How does the logbook self-erase?
The logbook is circular and will start erasing itself when all the memory places are filled. There are
approx. 3,800 memory places, each of which contain the altitude as well as the ascent/descent rate at
that time (according to the chosen interval, 20 seconds, 1 minute, 10 or 60 minutes).
To Next Page
Loading...
