Suunto Vector - PRESSURE DIFFERENCE MEASUREMENT MODE; 4-DAY MEMORY MODE

36
PRESSURE DIFFERENCE MEASUREMENT MODE
In the Barometric mode, PRESS the [Select] button once to enter this sub mode.
In the Pressure Difference Measurement mode:
 Field 1 displays the change in temperature.
 Field 2 displays the change in atmospheric pressure.
 Field 3 displays the current time; to the left of the time is the text differ.
 The Outer Circumference graphically displays the change in pressure where one full circle equals 100
mbars or 1 inHg.
This mode does continue in the background and allows the user to move to other modes and at the
users convenience can return to this sub mode to show the current reading.
How to Start the Pressure Difference Measurement
1. PRESS the [Select] button and hold for 2 seconds. Located in Field 1 is the text SET; located in Field
2, zero will begin to flash.
2. PRESS the [Mode] button to accept the flashing zero and start the difference measurement.
If the user does not desire to begin the difference measurement, PRESS either the [+] or the [-] button to
toggle to the current barometric pressure reading, then PRESS the [Mode] button to exit the setup
program.
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically
exit setup.
4-DAY MEMORY MODE
In the Barometric mode, PRESS the [Select] button twice to enter this sub mode. This feature allows the
user to follow changes in pressure that will assist forecasting changes in weather condition (i.e. storms).
In the 4-day memory mode:
 Field 1 displays the day of the week the user is in;
 Field 2 displays the atmospheric pressure; and
 Field 3 displays the time and to the left the text memory.