Suunto Vector - PRESSURE SENSOR CALIBRATION; CARE AND MAINTENANCE

13
9. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located at the
top center in Field 1, m/min or ft/min will begin to flash.
10.PRESS the [+] button to toggle between m/min and ft/min.
11.At the unit of measure desired, PRESS the [Mode] button to accept the changes. PRESS the [Mode]
button again to return to the main time mode.
Selecting the units of measurement is complete.
PRESSURE SENSOR CALIBRATION
Note: This calibration applies to the Altimax, Vector, and X-Lander.
This is a FACTORY SETTING CALIBRATION. If you are in this mode we highly suggest that you exit
this setting by pressing the [Mode] button. Calibrating this setting will ADVERSELY IMPACT all
altitude and barometric settings of the Wristop Computer.
In this setting, the user will be viewing SNR (Sensor) in Field 1. Do not press the [+] or [-] button to
adjust the pressure. Simply exit this setting by pressing the [Select] button to return to the UNI setting
mode or by pressing the [Mode] button to return to the main mode.
If the Pressure Setting Calibration has been altered, in error, please contact our Product Support
Department.
CARE AND MAINTENANCE
Perform only the detailed processes discussed in this manual. Do not perform any other service to the
Wristop Computer or attempt to open the case or remove the buttons or the bezel.
Protect your Wristop Computer from shocks, extreme heat and prolonged exposure to direct sunlight. If
not in use, your Wristop Computer should be stored in a clean, dry environment at room temperature.
The Wristop Computer can be wiped clean with a lightly moistened (warm water) cloth. Applying a mild
soap to the area can clean stubborn stains or marks.
Avoid exposing the Wristop Computer to strong chemicals like gasoline, cleaning solvents, acetone,
alcohol, adhesives, and paint, as they will damage the units seals, case and finish.
Never attempt to take the Wristop Computer apart or service it yourself. Make sure the area around the
sensors (backside of the instrument) is kept free of dirt and sand. Never insert any objects into the sensor
openings of the Wristop Computer.