Suunto Vector - Viewing the timed events individual lap and split times; Sail Timer Function

24
Viewing the timed events individual lap and split times
1. PRESS and hold the [Select] button for 2 seconds.
 Field 2 displays the event number CH # the user will be viewing; and
 Field 3 displays the text bEG (begin).
2. PRESS the [+] button to view the lap and split time which is in chronological order beginning with lap 1.
 Field 1 displays the seconds and tenths of seconds of the lap or split time;
 Field 2 displays the hours and minutes of the lap or split time; and
 Field 3 displays the text  L # or SPL (SPL = split time). The lap time will be viewed first the split
time will follow automatically.
3. PRESS the [+] button to continue viewing the reminder of lap and split times recorded. When the last
lap and split times have been viewed, the display will show in Field 2 CH #; and in Field 3 the text
End (indicating the end of this activity).
4. PRESS the [Mode] button once to exit and return to the chronograph memory sub mode.
Sail Timer Function
In the Chronograph mode, PRESS the [Select] button two times.
The display shows in:
 Field 1 the selected time to be counted down in minutes , maximum 10 minutes;
 Field 2 the time to be counted down in minutes and seconds; and
 Field 3 the current time and the text logbook to the left of the current time.
To set the count down, PRESS the [-] button, the selection will begin with 10 minutes. Continue pressing
the [-] button until the desired minute is achieved. The selected time is stored in Field 1.
To begin the count down, PRESS the [+] button.
During the count down the time will activate audible signals.
Interval Audible signal
Every full minute Short double beep
Every 10 seconds during the last minute Short double beep
Every second during the last ten seconds Short single beep
At the completion of the count down Long single beep